I believe the grains are close to the same but you cannot use the same MEC bushings for both
Early 70's. Very tough hulls. I loaded them probably as many as 20 times. Have a once fired one i will shoot for my 50,000th 16 yd target at my 50th...
my MX3 combo came with this wrench in about 1984
Believe Pachmyer in California had one of these years ago. Would not throw for me because i was only shooter. Wind is a real killer for this big sail...
Is Perazzi. I had several guns that had them. Think MX3 single barrel was one of them. Possibly my MT6 used it. Not sure of that.
Loaded some steel years ago when first had to go to it. Seem to remember that MEC made a special shot tube with alteration (not remember what) to the...
Seem to remember some years ago a shooter won the GAH from (not positive of this) 27yd line. Couple years later same shooter won again from a much...
Thanx, basically the same thing i found. Will go with the fig 8 wad as the last thing my rifle TM1 needs is a tighter pattern.
If clearances are right it will not go past the ejector coming out without the possibility of bending or breaking the ejector. See post #18 for easy...
Not familiar with a Kriegoff but on a Perazzi the ejector has to be in flush with the receiver before you can remove the locking piece. K gun...
Wire cutters. Cut off piece on base and rotate to ejector and pull out. Works on a P gun.
Shooting from the hip would be something to watch. Just be careful if Stafford shows up. Dan Bonillas was given a real lesson in hip shooting by Ray...
Add Dan Bonillas and Ray Stafford.
glad is working for you. There is no wrong way to break a target.
3/8 raise should have moved your POI up about 12". figure 2" for each 1/16" raised is the common theory i believe.
140% high??? really
Just out of curiosity did you ever get any of this at this price??
I call it the comatose class. I are one. Sporting clays has one. State shoot has only 3-4 entries.
any american made one. others are bigger and not load very good.
I have 2 very old ones that are both .727.
I refill both shot and powder after each 100 loaded. Gives you a break also. Problem solved.
I see WPT and (YAC) all the time. What does it mean?
Years ago loaded a turkey shooting shell that was close to 1400. Used 4756 powder #41 or 42 mec bushing (i think). One for AA hulls and the other for...
believe you can put chedites and fiochi 616's in the same hull stretching category. Have found the rule of thumb is if it is green(rem) load american...
want your eyes opened? run a factory AA .410 over the chronograph. Not know what they are now but 30 years ago were about 1350 if i remember right....
try increasing the radius where they fit behind the ears. Sounds like they are too tight. also make sure your hat is not pressing down on the frame....
How much difference is there between the fig 8 wad and the rxp wad. looking for a load with red dot powder and a win primer in the 1200+- range....
I use 19.7 gr in a 16 ga. load. Book i believe.
Shot a card shoot years ago and asked what restrictions,if any, were on what you shot at the card. Was told no restrictions as long as was a shotgun....
discussing any thing intelligently with a die hard democrat is like trying to pick up a turd by the clean end.
Have found that if it is green, load american primers. They do not like the force fit of the oversize primers.
Been a member for 55 years. Not use much but has been outstanding for the few times i have used them. One time on a lock out at a mountain gun club...
Lot of times local targets look longer than 44-46 yards although i have never physically measured them. Very few if any clubs have a distance or an...
How long since you shot Colorado targets? None at 40 yds. that i have shot in the last few years.
As Gomer Pile would say, "SURPRISE SUPRISE!!!!"
Am afraid if this is true you will create a whole bunch of "fair weather" shooters who will refuse to shoot in the cold or wind.
See post #64. I fit your description. Earned 27 in about 1976.
I spent 35 years on the 27 yd. line. Earned on 96+ scores. I deserved it then. Due to advancing age and worsening eye sight I REQUESTED and received...
currently in Denver is 5 with snow. Bahhhhh Humbug! Happy new year to all.
SOLD
Has been sold. No way to mark sold or cancel the add that i can find.
This was on a used gun i bought. Appears to be nearly new. Dimensions: H= 5 9/32", W= 1 13/16 in middle.(variable), D= 2 3/8" (this includes 1/2"...
Can't see orange for squat. Wish would go back to black. No lens color helps with orange. See green and pink fairly well. ANYTHING besides orange....
enjoy it. weather in Denver is in the 40's dipping into the 30's and high 20's. summer to winter it seems.
I have read a little on this and it seems to me his "offense" was tapping the barrel of his gun on the pad to unstick hulls that would not eject. WTF...
Love the idea. Not see how could throw a rabbit target off a regular trap machine. Years ago at the Wyoming state sporting clays shoot they had the...
Love to see it. Would sure make the shooter keep his head on the stock. I used to practice this with a puller that would pull the target any time...
Shot a similar situation at the Hawaii state shoot about 30+ years ago. Went to line as the only out of state shooters (4).We were squad 7. Squad 2...
Sun come up in the west in Phoenix? Sets in the east?
Separate names with a comma.
