Help with putting a trigger back into a browning bps

Discussion in 'Americantrapshooter.com. - Trapshooting forum.' started by vdt, Jul 23, 2020.

  1. vdt

    vdt Mega Poster Founding Member

    I no this is not the right place but need some help ,I have removed the rigger from this browning bps pump shot gun and having a problem getting it back in ,is there some one out there could please lend a hand
     
    vdt, Jul 23, 2020
    #1
  2. Sgoose

    Sgoose Mega Poster Founding Member

    See YouTube, Brownell has maintenance series on Browning BPS shotguns
     
    Sgoose, Jul 23, 2020
    #2
  3. CB630

    CB630 Well-Known Member

    I sold my bps years ago for thet same reason
    Need to clean it the shell cut off is not staked
     
    CB630, Jul 23, 2020
    #3
  4. Duck

    Duck Member

    vdt,
    See the pins on the side of the receiver that the trigger slides back in on. Each side has a flat, these get rotated when removing the trigger assembly. As you know the trigger will go back in but not into full alignment. Rotate the pins!. :)
     
    Duck, Jul 24, 2020
    #4
  5. vdt

    vdt Mega Poster Founding Member

    thank you ,the u-tube shows that
     
    vdt, Jul 24, 2020
    #5