An estimate of cost to Rebuild and Re-nickel a CG Syren receiver and Iron.

Has anyone had a Caesar Guerini receiver and iron completely rebuild to like new spec's recently, including a re-nickeling and could give me the cost?
I'm assuming only CG could do this because of their control over parts. Thank you.

 

Not sure on the internals. I had my daughter’s Caesar summit renickled.
I had to raise a lil stink and they did it for 500 shipped.
It will have to go back to Italy and took 6 months
Good luck

 

WoW, i understand the cost, but six months?

 

I have an Invictus V that needs the finish redone as well. I asked the rep at the OH state shoot about it. He said the same as above. Around $600 and shipped back to Italy. 6mo turnaround.

 

Looks like they don't stand behind what they make/sell..... I've seen several with finish problems.. instead a friend had his Cerakoted....looks great....

 

Creosote, the way to got bad Robar is out of business they had a finish that was impervious to everything

 

Phillip's Gunsmithing told me about $400-500 and four weeks. Will not do any repairs or replace any internal receiver parts because they are unable to buy parts from CG.

 

You can buy firing pins from target shotguns.
Guiliani makes them aftermarket