k80 foreend iron screws torq specs

Discussion in 'Americantrapshooter.com. - Trapshooting forum.' started by marc marcellini, Dec 19, 2023.

  1. marc marcellini

    marc marcellini Member

    Hello,

    I have a friend who just got replacement screws for his k80 fore end that holds the iron to the woo that screw into the rosettes my question for him is does anyone know if there's a certain Torq to put these at so not to overtighten and strip or break off screws or damage the foreend??

    Thanks!
    Marc
     
    marc marcellini, Dec 19, 2023
    #1
  2. Smokintom

    Smokintom Mega Poster Founding Member

    Yes it’s called snug.
    Not tight
     
    Smokintom, Dec 20, 2023
    #2
    oleolliedawg likes this.
  3. Jon Reitz

    Jon Reitz Well-Known Member V I P

    Be sure to use some thread lock.
     
    Jon Reitz, Dec 20, 2023
    #3
    Smokintom likes this.
  4. Smokintom

    Smokintom Mega Poster Founding Member

    Blue not red
     
    Smokintom, Dec 20, 2023
    #4
  5. Wildcat Lewis

    Wildcat Lewis Active Member

    20-22 inch pounds and use blue lock tight...........
     
    Wildcat Lewis, Dec 22, 2023
    #5
  6. Roger Coveleskie

    Roger Coveleskie State HOF Founding Member Member State Hall of Fame

    ALSO CHECK THE WOOD TO METAL FIT. IF THERE IS A VERY SMALL GAP THE SCREWS WILL SHEER. EVEN IF YOU USE LOCK TITE ROGER C.
     
    Roger Coveleskie, Dec 28, 2023
    #6
  7. 37 COUPE

    37 COUPE Well-Known Member

    Careful o boy your going to cry if it cracks very light tighten and shoot it check shoot it check
     
    37 COUPE, Dec 30, 2023
    #7