K32 San Remo Grade combo, custom wood. $7500.00...SPF

Extremely clean, very tight, virtually no bluing wear, unmolested, screws show never been touched by a screw driver, safe queen for years, 30" o/u Mod/Full, 34" over single light Full. Custom wood, few slight handles marks
Stock 14-3/4" - 1-1/2" 1-1/8 slight M/C with adjustable butt pad. Serial number 3xxx with matching o/u barrel single barrel different SN, engraving on the barrel shoulders to match the receiver, Don't recall a factory K32 combo ? $7500.00 $75.00 shipping.
.
Joescout, Reno, Nv.

 

Can you post a better picture of the right side of the receiver?

 

Now that's a picture ! Not sure how I did that.

 

joe, are the shoulder engravings on the extra bbl factory or, a different design?

 

Not an expert on engraving but it's a pattern simular to another K32 single that I owned. I have another k32 with a top single with no engraving but I think that barrel is off of a k80. The matching serial numbered over and under barrel does not have engraving on the shoulders as does the top single. See picture of single barrel.

Tks, Joe

 

Bobski, just noticed that the top locking cap/hood has similar engraving as does the single barrel. See picture the large photo above.

Joe

 

thanks joe. that s-bbl is tempting. im going to assume its an 8mm straight rib, right?

 

8mm straight, choke .028.
Years ago one my trapshooting buddies was general manager for a local Chevy dealership he had a yard stick glued to the front of his desk - it was when the new Chevy Camaros came out and guys who were now in their 60s who now could afford that new Camaro that they always wanted since high-school were looking to buy - if they started to get a little wishy-washy about the purchase Bob would ask them where did they fall age wise on the ruler most would point at 65/66 and then Bob would say you know life expectancy for a male is around 72 years of age so it looks like you only have about 6" left on life's ruler - out came the check book.

 

lol!!!!!!!!!

 

Up

 

Please confirm stock dimensions: DAC, DAMC, DAH, Cast? Can you post a photo of the bottom of th grip cap? Any recent service history? Thanks.

 

Cast is neutral- comb mostly parallel 1-1/2" 1-1/2" 1-3/4" most all of my guns I have put adjustable combs on - seldom will any off the shelf shotgun fit me same with all my rifles- why waste time - just make them fit - If I intended to shoot this gun alot it would have an adjustable comb on it - I've got a couple k32s and a k80 that I shoot and also have extra stocks. If I wanted to shoot this particular gun I would switch out the stocks in order not to ding the ones that are on it, I've recently shot the gun with both barrels wanted to show it off. I do have a nice reworked set of k32 stocks with a spacer in the butt stock that I could swap out if needed but these stocks that are on the gun are very nice. Don't know the passed history on the gun it just caught my eye and I bought it because it was in such great condition.

Joe
Joe

 

Newer k80 barrel. No screws on ejectors.

 

The single barrel was an addition to the gun the O/U 30 "barrel is the original barrel serial numbers match receiver - although the serial numbers are not far apart. I've got another beautiful trap k32 never put a round though it but just like to have it around.

Tks, Joe

 

Sold pending funds.

Tks,
Joescout